Table of Contents
Advertisement
70
GETTING TO KNOW YOUR VEHICLE
The following options are available to you when lower-
ing your vehicle's soft top:
•
Sunrider® position with rear and quarter windows
installed
•
Sunrider® position with rear and quarter panels
removed
•
Sunrider® position with rear window installed and
quarter panels removed
•
Fully lowered position with rear and quarter windows
removed
Both quarter windows should be removed and installed
together.
Lowering The Soft Top Into Sunrider® Position
1. Fold both sun visors forward against the windshield.
2. Release the header latches from the crossbar by
pulling the handle downward. Make sure the hook is
disengaged from its receiver.
Step Two
3. From both the left and right sides, lift up on the
#1 Bow of the soft top to start the operation.
Step Three
4. Move to the side of the vehicle and use the side link
to fold the soft top rearward into the Sunrider®
position.
Step Four
NOTE:
If leaving the soft top in the Sunrider® position,
secure the top by using the two hook-and-loop fas-
teners provided in the center console.
Step Four
NOTE:
•
The vehicle can be driven in the Sunrider® position
with the rear window and quarter panel assemblies
fully installed or completely removed.
•
The rear window and rear quarter windows must be
removed before fully lowering the soft top to prevent
damage to the top. Clean the side and rear windows
before removal to assist in preventing scratching
during removal of the soft top. If the plastic retain-
ers are difficult to operate due to road dust, etc.,
clean them with a mild soap solution and a small
brush. Cleaning products are available through an
authorized dealer.
Removing The Soft Top Windows
NOTE:
Before fully lowering the soft top, the rear window and
rear quarter windows must be removed.
Advertisement
Table of Contents
