Table of Contents
Advertisement
88
GETTING TO KNOW YOUR VEHICLE
Attach Rear Door Rail Bolt
5. Repeat steps 3 and 4 on the other side of the
vehicle.
NOTE:
The recommended torque specification for the front
and rear door rail attachment bolts is 8.8 ft-lb
(12 N·m).
6. Attach the rear clamp at the rear center of the
Sunrider® top using the two provided rear clamp
attachment bolts. Tighten with #40 Torx head driver
until snug.
Rear Clamp Location
NOTE:
The recommended torque specification for the rear
clamp attachment bolts is 3.7 ft-lb (5 N·m).
7. From inside the vehicle, lift and pull the Sunrider®
top forward using the integrated handle on the front
header of the top. Manually guide the top into the
closed position.
Push Sunrider® Top Forward
8. From inside the vehicle, pull the handle on the
header latch downward to engage the hook into its
receiver. Pull the handle back upward while squeez-
ing the hook, locking the latch into place. Repeat on
the other side.
Engage Both Header Latches
To Open The Sunrider® Top
To open the Sunrider® top, proceed as follows:
1. Fold both sun visors forward against the windshield.
2. Release the header latches from the crossbar by
pulling the handle downward. Make sure the hook is
disengaged from its receiver.
Advertisement
Table of Contents
