Gardner Denver ELECTRA-SAVER II Service Manual page 9

Safety is everybody's business and is based on your use of good common sense All situations or circumstances cannot
always be predicted and covered by established rules Therefore use your past experience watch out for safety hazards
and be cautious
Some general safety precautions are given below
, WARNING
STOP THE UNIT IF ANY REPAIRS OR ADJUSTMENTS ON OR AROUND THE
COMPRESSOR ARE REQUIRED.
ALL COMPRESSED AIR SUPPLY HOSES EXCEEDING 1/2 INCH INSIDE
DIAMETER SHOULD HAVE AN EXCESS FLOW VALVE (OSHA REGulation
SECTION 151 8.302)
DO NOT EXCEED THE RATED MAXIMUM PRESSURE VALUES SHOWN ON
THE NAME PLATE
DO NOT OPERATE UNIT IF SAFETY DEVICES ARE NOT OPERATING PROP-
ERLY. CHECK PERIODICALLY. NEVER BYPASS SAFETY DEVICES
DANGER
KEEP FINGERS AND CLOTHING AWAY FROM
REVOLVING FAN,
DRIVE
COUPLING, ETC.
DO NOT USE THE AIR DISCHARGED FROM THIS UNIT FOR BREATHING –
NOT SUITABLE FOR HUMAN CONSUMPTION.
DO NOT LOOSEN OR REMOVE THE OIL FILLER PLUG, DRAIN PLUGS
COVERS
THE THERMOSTATIC MIXING VALVE or BREAK ANY CON-
NECTIONS ETC. IN THE COMPRESSOR AIR OR OIL SYSTEM UNTIL THE
UNIT IS SHUT DOWN AND THE AIR PRESSURE HAS BEEN RELIEVED.
ELECTRICAL SHOCK CAN AND MAY BE FATAL
COMPRESSOR UNIT MUST BE GROUNDED IN ACCORDANCE WITH THE
NATIONAL ELECTRICAL CODE
FAN MOTORS HAVE BEEN AND MUST REMAIN GROUNDED TO THE
MAIN BASE IN ACCORDANCE WITH THE NATIONAL ELECTRICAL CODE
OPEN MAIN DISCONNECT SWITCH BEFORE WORKING ON THE CONTROL
DISCONNECT
THE COMPRESSOR UNIT
FROM ITS POWER SOURCE
BEFORE WORKING ON THE UNIT – THIS MACHINE IS AUTOMATI-
CALLY CONTROLLED AND MAY START AT ANY TIME
13-9-630 Section 1 Page 3