Table of Contents
Advertisement
TROUBLESHOOTING GUIDE
Problem
Screen shows
"No Signal
Input"
Note:
Motherboard will
Monitor
boot up without
not
the monitor
working.
plugged in, but
game will not
play.
Power
down, wait
5 minutes
Screen has
and power
nothing at all
up again.
on power up.
Error on
screen at
power up.
Re-Boot
game to see if
problem still
exists.
Ensure Light Board is
LED color strips
receiving voltage from
are not working
Power Distribution Board.
LED's receive
Ensure USB cable has
voltage from
good communication to the
Light Board in
motherboard.
the front of the
game.
Faulty LED
Front Power Supply or
Conveyor Belt
Running
Backwards
Check dipswitches on the
Conveyor Motor Control
Board .
Probable Cause
Monitor HDMI cable unplugged. There are 2 cables that are
connected together -
Faulty or loose RAM
Large power connector unplugged on motherboard
Small power connector unplugged on motherboard
Faulty power supply -
Refer to Power Supply diagnostic section
Faulty motherboard - Replace faulty board.
(AAMB13-HD/AXM)
Note: If MB13 in the game, check the same items,
although locations may be different.
Power cable
unplugged from
Monitor.
Turn on Monitor.
Faulty monitor.
Display shows
"Kernel panic –
unable to mount root"
Display stuck on
"Motherboard" Bios
Motherboard faulty.
A5CORD29000 and A5CORD29001
Ensure power is plugged into back of monitor, down
to power strip. There are multiple power cords.
A5CORD5003, A5CORD1, A5SP4100, and A5CORD1
Install batteries in remote control and try using
remote control to power on monitor.
Replace monitor. (A5MO0032B)
Faulty or loose RAM, faulty
software, faulty motherboard
No software seen by motherboard.
If SATA drive - Check for power connector
If hard drive - Ensure it is seated
onto motherboard.
Refer to wiring diagram. Check connections and reseat
cables from Power Distribution Board to Light Board..
Cable # AACE29011
Refer to wiring diagram. Check connections and reseat
USB cable from Motherboard to Light Board..
Cable # A5CBL5900
Refer to wiring diagram. There are some cables that plug
into Light Board and some that plug into the Control
Board. Some lights direct to Power Distribution Board.
If the Conveyor Motor Control Board is not receiving cor-
rect signals, the default mode of the conveyor motor is to
run backwards.
Troubleshoot power supply or motherboard issue.
Dipswitches must be set this way
59
Remedy
AAMB12-HD/AXM
Motherboard
Important!
Advertisement
Table of Contents
