Bay-Tek AXE MASTER Service Manual page 19

Install the square metal connector plates at the top left and right
edge of the wood piece as shown.
4 of the black ¼-20 X 1 Phillips head bolts
using a # 3 Phillips Head bit.
2 per bracket.
Attach upper safety wall to lower safety wall:
Important:
The upper safety wall is large and heavy.
Use 2 or more people to lift the upper safety
wall to the top of the lowe safety wall.
Align the upper safety wall with the holes in
the connector plates just installed.
Secure with 10 of the black ¼-20 X 1 Phillips
head bolts using a # 3 Phillips Head bit.
Install front marquee onto safety wall.
Using 2 people, carefully lay down the safety wall down onto the floor, and position marquee as shown.
Push the wires from the middle hole on the safety wall up into the marquee and plug into the connectors
inside the marquee. (CE29076 to CE29072)
The 2 end wires can be pushed slightly into the holes, they will be connected later.
Move marquee against safety wall and make sure wires will not get pinched as the marquee is attached.
Secure the double monitor housing to the cabinet by installing 2 bolts/washers/split washers down
through the marquee into the safety wall.
Use 2 of the 25-20 , 1 1/2 inch bolts with split
washers and washers using a 7/16" wrench.
AXE MASTER SETUP
A5BOPH312
A5BOPH312
A5BOHH060
19
A5WASI020 A5WAFL060