Table of Contents
Advertisement
Parameter
Fault Check
5.5 Network Configuration
On the General Config of the Device Details screen, tap Network Configuration, and then you
can select network for the hub: wired network, wireless network, or cellular network.
5.5.1 Wired Network Configuration
Procedure
Step 1
Select Network Settings > Wired Network Config.
Step 2
Configure wired network connection parameters.
Parameter
DHCP
IP Address
Subnet Mask
Gateway
DNS
DNS 2
MAC Address
Description
Main Power Failure : It is enabled by default. After disabling, when the
●
main power of the hub fails, the hub will not indicate and notify.
Alarm Hub Tamper : It is enabled by default. After disabling, when the
●
lid of the hub is open, the hub will not indicate and notify.
Connections to Cloud Platform : It is enabled by default. After
●
disabling, when the connection between the hub and cloud platform is
abnormal, the hub will not indicate and notify.
Wired Network and Wi-Fi Errors : It is enabled by default. After
●
disabling, when the wired network and Wi-Fi of the hub fails, the hub
will not indicate and notify.
Cellular Network Errors : It is enabled by default. After disabling, when
●
the cellular network of the hub fails, the hub will not indicate and
notify.
RF Jamming : It is enabled by default. After disabling, when the hub
●
detects RF jamming, the hub will not indicate and notify, but the event
can be viewed in the log.
Disabling any of these functions will cause the system to not comply with
EN50131-1, and the error messages will not be sent related to the disabled
function.
Table 5-4 Description of wired network parameters
Description
When there is a DHCP server on the network, you can enable
DHCP, and then the hub gets a dynamic IP address
automatically.
Set the IP address manually: Set IP address, subnet mask,
default gateway, DNS and MAC address manually for the hub.
46
User's Manual
Advertisement
Table of Contents
