Table of Contents
Advertisement
Parameter
Alarm Center
Description
Enable Monitoring Station, and then set the SIA protocol parameters
for the alarm receiving center (ARC).
Preferred IP address : Enter the IP address and port number of the
●
ARC.
Alternative IP address : Enter the alternative IP address and port
●
number of the ARC.
Messages will be sent to the alternative IP address only when the
preferred IP address fails to receive the message.
If Heartbeat interval is enabled, the system will judge whether
to send the message to the preferred or alternative IP address.
IP Protocol : Select TCP by default.
●
Heartbeat interval : Set the heartbeat interval with the range from 0
●
second to 24 hours (60 seconds by default).
0 seconds means Heartbeat interval is disabled.
Central account : Enter the account number that created by the ARC,
●
which is to be used to identify the hub when the hub sends
information to the ARC.
Encryption : The hub uses an encryption format for information
●
security when you configure the ARC. AES128 is set by default.
Upload event : Tap
●
Alarm : Alarm message.
Error : Power failure, battery under-voltage, tamper, and offline.
Event : Prohibit the use of peripherals, add or delete peripherals,
and add or delete users.
Arm/Disarm : Message notifications of arming and disarming the
system.
Communication Test : Supports Manual Test and Scheduled Test.
●
Manual Test : Manually test whether the parameters of the
preferred and alternative alarm centers are normal. If the test is
successful, the center can receive the test event.
Scheduled Test : Scheduled test is disabled by fault. After
enabling, the hub reports periodic test event regularly.
30
next to an event to upload it.
User's Manual
Advertisement
Table of Contents
