Watchguard ALMKIT-D1 User Manual page 50

Parameter Description
Arm or disarm the areas by schedule.
●
●
Schedule Arming/
Disarming
●
●
●
Ringtone Setting The ringtone when entering or exiting the arming mode.
LED Indicator is enabled by default.
●
LED Indicator
●
Tap Add on the upper-right corner of the page to add a phone number to
receive the event, and then select the event type that needs to send SMS.
The event types include alarm, fault, operation, and whether the alarm is
linked to the phone.
After adding, you can swipe left to test phone calls and SMS messages to
Phone Number
verify whether the current phone number is valid. You can also swipe left
Management
to delete the mobile phone number.
Tap the phone number to enter the phone number editing page, and then
you can edit the number and select the event type that needs to send SMS.
Only 2G/4G devices support this function.
Tap Start to test the status of the peripherals connecting to the hub in
Test Mode
different areas, and then tap Stop to complete detection.
Enable Reduced Sensitivity Mode, and then the hub's transmit power will
be reduced.
Reduced Sensitivity
Mode
The function is only available when the version of the DMSS app is 1.97 or
later, and the hub is V1.001.0000000.6.R.211215 or later.
Set the server-hub ping interval with the range from 150 to 900 seconds
(150 seconds by default). If the D-cloud detects that the hub's offline
duration exceeds 150 seconds, it will report the hub status to the user
through app.
Cloud Service
Connection
The function is only available when the version of the DMSS app is 1.96 or
later, and the hub is V1.001.0000000.6.R.211215 or later.
Area : Select the area in which the hub operates.
Command setting : Select an armed mode as needed by tapping
Home, Away, or Disarm.
Time : Select the time period in which the hub operates.
Repeat : Copy the arming or disarming schedule.
Force Armed : You can arm the system when errors happen in zones.
If LED Indicator is disabled, the LED indicator will remain off regardless
of whether the hub is functioning normally or not.
The function is only available when the version of the DMSS app is 1.96
or later, and the hub is V1.001.0000000.4.R.211014 or later.
43
User's Manual