Watchguard ALMKIT-D1 User Manual page 36

Parameter
Heartbeat
Link Siren for Tamper
System Integrity Check
CMS
Description
Configure the hub-detector ping interval. The settings determine how
frequently the hub communicates with the peripherals and how quickly
the loss of connection is detected.
Detector Ping Interval : The frequency of connected peripherals
●
operated by the hub is configured in the range of 12 seconds to 300
seconds (60 seconds by default).
The shorter the detector ping interval, the shorter the life span of the
battery.
Number of undelivered packets to determine connection failure :
●
A counter of undelivered packets is configured in the range of 3 to 60
(15 packets by default).
The smaller the number, the more frequently the offline status of
peripherals is detected and reported.
If the hub constantly loses connection with the peripherals and
cannot detect their defined heartbeats, it will report their offline
status to the system.
Link Siren for Tamper : In the arming state, when the Link Siren for
●
Tamper is enabled, the hub will link the alarm sound.
The siren will alert when the lids of the hub and peripherals are open.
Always Active : Configure whether to link the alarm sound in the
●
disarming state. It is disabled by default. After enabling Always
Active, when the Link Siren for Tamper is enabled, the hub will link
the alarm sound in both arming and disarming state.
This is not according to EN50131-1 certifications.
When enabled, the hub checks the status of all detectors before arming,
such as battery charge level, tamper incidents, and connectivity. If errors
are detected, warnings will be displayed.
For the keyfob, the indicator flashes green, and then turns red.
●
For the app, an alarm message pops up.
●
For the keypad, it beeps for 1 second, the arming and disarming
●
indicator flashes green for 2 seconds, and then it turns to the normal
status.
Enter IP address, port and device ID, and then you can register the hub
to the DSS Pro or Converter.
29
User's Manual