Connecting The Coil To The Generator; Clip Attachment And Removal; Administering The Treatment; Coil Positioning - IGEA I-ONE User Manual

IGEA I-ONE - User Manual
3.2

Connecting the coil to the generator

The coil that is compatible with the I-ONE is shown in the figure below, identified by its code:
REF. 70010 REF. 70110
Insert the coil connector into the coil socket on the left side of the
generator (P), pressing down until you hear a 'click'.
P
When switched on, the device will automatically recognise the
connected coil and emit the required alarm level.

4. CLIP ATTACHMENT AND REMOVAL

If necessary, the generator can be clipped onto the belt using the supplied clip, so that the treatment can also be
carried out on the move.
To fit the clip, engage one side notch in the slot provided
and apply light pressure to the centre of the clip until the
second notch is also fully engaged.
The generator can now be attached to the belt.
To remove the clip, press gently in the centre to release
the first side notch from its socket, followed by the second.
Now lift the clip and remove it.
6 Page 5