Epilog Laser Fusion Maker Assembly Replacement page 6

17000 X-Axis Assembly Replacement
3. Install and tighten the four (4) fasteners
that secure the x-axis assembly to the
y-axis bearings. There are two (2) on
the right side and two (2) on the left
side:
4. Place the x-axis drive board and
housing into position:
5. Install and tighten the three (3) Phillips
screws that secure the x-axis drive
board mounting bracket to the x-axis
assembly:
6. Connect the six (6) electrical harnesses
on the drive board:
7. Connect the air assist tubing to the
right side of the x-axis assembly:
6