Epilog Laser Fusion Maker Assembly Replacement page 4

17000 X-Axis Assembly Replacement
7. Remove the six (6) electrical
connections on the drive board:
8. Loosen and remove the three (3)
Phillips screws that secure the x-axis
drive board mounting bracket to the
x-axis assembly:
9. Remove the x-axis drive board and
housing:
10. Disconnect the belows on the left and
right side of the engraver.
11. Remove the four (4) fasteners that
secure the x-axis assembly to the
y-axis bearings. There are two (2) on
the right side and two (2) on the left
side:
4