Epilog Laser Fusion Maker Assembly Replacement page 3

17000 X-Axis Assembly Replacement
X-Axis Assembly
Replacement
X-Axis Assembly Removal
1. Turn off the engraver.
2. Disconnect the engraver from power
source.
3. Remove the left and right panels of the
engraver:
4. Loosen and remove the lens tube
assembly from the x-axis assembly:
5. Remove the x-axis drive board cover:
6. Disconnect the air assist tubing from
the right side of the x-axis assembly:
The AA tubing is held by a tubing coupler.
To remove the tubing, press the tubing
into the fixture. Then, while holding the
retaining ring tight to the fixture, pull the
AA tubing away from it.
3