Table of Contents
Advertisement
IO-Link error
X.TUNE error occurred
Actuator supply is down
POS.Monitor
CMD sensor break
Table 16:
Messages
36
No valid process data is
received
The last X.TUNE was not
successful.
The actuator supply voltage is
too low. Only with IO-Link
The set-point position is not
reached
Cable break of the set-point
value signal.. The message can
be parameterized (see "16.2.7")
english
Type 8694 REV.2
Control and display elements
- Check connection to the IO-Link master
- Check whether valid setpoints are sent to
the device via the IO-Link interface
-Check compressed air supply
-Run X.TUNE again
Check actuator supply voltage
-Run X.TUNE
-Check compressed air supply.
Check the signal line of the set-point value
Advertisement
Table of Contents
