Burkert 8694 REV.2 Operating Instructions Manual page 29

Type 8694 REV.2
Control and display elements
AUTOMATIC operating state (DIP switch 4 set to OFF):
Button Function
1 Start the X.TUNE function: press button for 5 seconds until LED 2 (green) flashes
2 -
Longer than 10 s (< 30 s, LED 2 flashes at 5 Hz): Device restart
1 and 2
simultane-
ously
Longer than 30 s (LED 2 flashes at 10 Hz): Reset device to factory setting
Table 8: Configuration of the buttons for AUTOMATIC operating state
Figure 14: Position of the seal in the body casing
ATTENTION!
Breakage of the pneumatic connection pieces due to rotational impact.
▶ When unscrewing and screwing in the body casing or transparent cap, do not hold the actuator of the
process valve but the basic housing.
Damage or malfunction due to penetration of dirt and humidity.
▶ To observe degree of protection IP65 / IP67, screw the transparent cap in all the way.
→
Close the device (assembly tool: 674077
14) The assembly tool (674077) is available from your Bürkert sales office.
Body casing
Seal
body casing
Basic housing
).
14)
english
29