Status Led, Green - Burkert 8694 REV.2 Operating Instructions Manual

7.5.1.3 NAMUR mode
The device status LED show the device status.
The display elements change color in accordance with NAMUR NE 107.
If several device statuses exist simultaneously, the device status with the highest priority is displayed. The
priority is determined by the severity of the deviation from controlled operation (red LED = failure = highest
priority).
Status display in accordance with NE 107, edition 2006-06-12
Color Color code Status
Red 5
Orange 4
Yellow 3
Blue 2
Green 1
Table 13: Description of the colors
7.5.2

Status LED, green

LED 2 (green) indicates the following:
Color Status
Green is not lit
flashes
flashes with 5 Hz
flashes with 10 Hz
Table 14: LED 2, green
20) Only IO-Link variant.
34
Outage, error or
malfunction
Function check
Out of specification
Maintenance required The device is in normal operation, although a
Diagnostics active
Description
IO-Link communication inactive
IO-Link communication active
Feedback during pressing button 1 (start X.TUNE) or button 1+2
(device restart) > 5 s
Feedback during pressing button 1+2 (reset to factory settings)
> 30 s
english
Type 8694 REV.2
Control and display elements
Description
Normal operation is not possible due to a mal-
function in the device or on its peripheral equipment.
Work is being carried out on the device; normal ope-
ration is therefore temporarily not possible
Ambient conditions or process conditions for the
device are outside the specified area.
function is briefly restricted.
→
Service device.
Device is operating perfectly. Status changes are
indicated in different colors.
Messages are transmitted via a fieldbus if connected.
20)
20)