Nvidia Spectrum-2 SN3000 1U User Manual page 41

Switch systems hardware
Hide thumbs Also See for Spectrum-2 SN3000 1U:
Table of Contents

Advertisement

Baud Rate
Data bits
Stop bits
Parity
Flow Control
Step 3. Login as admin and use admin as password. On the first login, the NVIDIA Onyx (MLNX-OS)
configuration wizard will start.
Step 4. To configure network attributes and other initial parameters to the system, follow the
configuration wizard as shown in the Configuration Wizard Session table below.
Configuration Wizard Session
Wizard Session Display
NVIDIA configuration wizard
Do you want to use the wizard for initial
configuration? yes
Step 1: Hostname? [switch-1]
Step 2: Use DHCP on mgmt0 interface? [no] yes
Step 3: Enable IPv6? [yes]
Step 4: Enable IPv6 auto-config (SLAAC) on
mgmt0 interface? [no]
Step 5: Enable DHCPv6 on mgmt0 interface?
[no]
Step 6: Admin password (Press <Enter> to leave
unchanged)? <new_password>
Step 6: Confirm admin password?
<new_password>
You have entered the following information:
<A summary of the configuration is now
displayed.>
To change an answer, enter the step number to
return to or hit <enter> to save changes and
exit.
Choice: <Enter>
Configuration changes saved.
Parameter
115200
8
1
None
None
Comments
You must perform this configuration the first time you
operate the system or after resetting the system. Type
'y' and then press <Enter>.
If you wish to accept the default hostname, press
<Enter>. Otherwise, type a different hostname and
press <Enter>.
Perform this step to obtain an IP address for the
system. (mgmt0 is the management port of the
system).
If you wish the DHCP server to assign the IP address,
type 'yes' and press <Enter>.
If you type 'no' (no DHCP), then you will be asked
whether you wish to use the 'zeroconf' configuration
or not.
If you enter 'no' (no Zeroconf), you must enter a static
IP, and the session will continue.
The management interface will be able to use IPv6
addresses.
If you enter "no" (no IPv6), you will automatically be
referred to Step 6.
This turns on auto-configuration of the IPv6 addresses.
This is unsuitable for DHCPv6.
To enable DHCPv6 on the MGMT0 interface.
To avoid illegal access to the machine, please type a
password and then press <Enter>. Then confirm the
password by re-entering it. Note that password
characters are not printed.
The wizard displays a summary of your choices and
then asks you to confirm the choices or to re-edit
them.
Either press <Enter> to save changes and exit, or enter
the configuration step number that you wish to return
to.
Note: To re-run the configuration wizard, run the
command "configuration jump-start" in Config mode.
Setting
41

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Spectrum-2 SN3000 1U and is the answer not in the manual?

This manual is also suitable for:

Spectrum-2 sn3000 2u

Table of Contents