Initial Power On - Nvidia Spectrum-2 SN3000 1U User Manual

Initial Power On

Each system's input voltage is specified in the Specifications chapter.
The power cords should be standard 3-wire AC power cords including a safety ground and rated for
15A or higher.

The system platform will automatically power on when AC power is applied. There is no
power system. Check all boards, power supplies, and fan tray modules for proper insertion
before plugging in a power cable.
1. Plug in the first power cable.
2. Plug in the second power cable.
3. Wait for the System Status LED to turn green.

It may take up to five minutes to turn on the system. If the System Status LED shows
amber after five minutes, unplug the system and call your NVIDIA representative for
assistance.
4. Check the System Status LEDs and confirm that all of the LEDs show status lights consistent
with normal operation as shown in the figure below. For more information, refer to "LEDs".
SN3700/SN3700C/SN3750-SX

After inserting a power cable and confirming the green System Status LED light is on, make
sure that the Fan Status LED shows green.
If the Fan Status LED is not green, unplug the power connection and check that the fan
module is inserted properly and that the mating connector of the fan unit is free of any dirt
and/or obstacles. If no obstacles were found and the problem persists, call your NVIDIA
representative for assistance.
Two Power Inlets - Electric Caution Notifications:
SN3420
39