Connect With Rs485 - Honeywell Voyager 147 Series User Manual

Note: The power supply must be ordered separately, if needed.
1. If you are connecting a CCB01-010BT-V1N Base, make sure the cables are
2. Plug the serial connector into the serial port on your computer. Tighten the two
3. Once the scanner or cordless base has been fully connected, power up the
This interface programs 115,200 baud, 8 data bits, no parity, and 1 stop bit.

Connect with RS485

A scanner or cordless base can be connected for an IBM POS terminal interface.
Voyager XP User Guide
CCB01-010BT-V1N Base
RS232 Serial Port Connection:
secured in the wireways in the bottom of the cordless base and the base sits flat
on a horizontal surface.
screws to secure the connector to the port.
computer.
5