Table of Contents
Advertisement
9.5 Control Board Removal and Installation
WARNING: If burner and/or pilot have been burning, use
appropriate protection to avoid burns or damage to per-
sonal property before removing any components.
DO NOT OPERATE THIS APPLIANCE WITHOUT THE SEAL-
ING GASKET (LOCATED UNDER THE CONTROL BOARD) IN
PLACE. IF GASKETING IS DAMAGED, IT MUST BE RE-
PLACED.
CAUTION: Check all connections for leaks with soapy wa-
ter, whether field or factory made.
9.6.1 Control Board Removal
1.
Disconnect electrical power. Locate the main shut-off
valve upstream of the appliance connector and close
valve.
2. Remove the (4) screws securing the log rack/media
tray.
3.
Remove front light kit (2) screws. Loosen (2) 7/16"
nuts to remove left and right burner assemblies.
4.
Remove rear burner assembly (2) screws and remove
rear burner assembly.
5.
Remove the (4) screws that secure the back media
tray that covers the back bottom light kit.
6.
Remove the (8) screws securing the control board. Lift
the control board out of the firebox, being careful not
to damage the sealing gasket underneath.
7.
Pull out control board out to reveal gas line to discon-
nect the gas line flex tube from fireplace valve.
9.6.2 Control Board Installation
1. Place control board in the firebox, aligning the holes
in the control board with the holes in the firebox
bottom. VERIFY SEALING GASKET IS IN PLACE.
2.
Secure the control board to the firebox using (8)
screws previously removed.
3.
Reinstall the back media tray using the (4) screws pre-
viously removed.
4.
Reinstall the rear burner assembly using the (2)
screws previously removed.
5.
Reinstall left burner assembly pushing it towards cen-
ter until it stops against the rear burner, then secure.
Repeat this process with the right burner assembly.
Tighten previously loosened burner nuts.
6.
Reinstall front light kit with (2) screws previously re-
moved.
7. Reinstall log rack/media tray with the (4) screws pre-
viously removed.
8.
Reconnect electrical power.
9.
Verify proper log placement, operation of fireplace,
and any electrical components.
Hussong Mfg. Co, Inc.
NDK-48-DV - PFS Report No. 23-196
Figure 9.12 - Step 1
Figure 9.13 - Step 2
Figure 9.14 - Step 3
47
Starting Serial Number: 24 N48DV00001 04
Rev. 1 - November 2023
Advertisement
Table of Contents
