Installation Information; Intended Use; Getting Started; Unpacking And Equipment Supplied - Sartorius PMA.Evolution Installation Instructions Manual

2.2 Installation Information

Do not operate the scale if its housing or AC
adapter including all connections are damaged.
Immediately disconnect the damaged device
from the power by pulling the plug.
Do not expose the scale, its AC adapter or the
accessories supplied by Sartorius to extreme
temperatures, aggressive chemical vapors,
moisture, shocks, vibrations or strong electro-
magnetic fields. Observe the conditions of
operation described in the Specifications.
The operator shall be solely responsible for
any modifications to the equipment and for
connecting any cables or equipment not
supplied by Sartorius! Information on
operational quality is available upon
request from Sartorius.
You should only use peripherals supplied
by Sartorius.
Note the IP protection class of the scale and
its AC adapter. Do not allow liquid penetration.
The protection class specifies the suitability of
equipment for various environmental conditions
(moisture, foreign bodies).
Before cleaning the AC adapter or the scale:
Unplug from the mains power.
The scale may only be opened by specialized
personnel trained by Sartorius. Do not open the
AC adapter.
Warnings Concerning Installation and Operation:
Lay the cables where they pose no risk of
causing someone to trip.
Never close a paint can using a hammer while it
is still on the weighing pan.
When closing, place the paint can on a firm,
stable surface.
Observe the additional safety and danger information in the
following chapters.

2.3 Intended Use

This scale is only intended for mixing colors and paints outside
of potentially explosive atmospheres. Appropriate containers
must be used for each type of material.
The scale can be operated via the keypad as a stand-alone
device or using application software (such as a paint-mixing
program from a paint manufacturer) installed on a connected
PC.
4 Installation Instructions EVO1S1 | SPO1S1

3. Getting Started

The scale must be disconnected from the power
supply for all assembly work.

3.1 Unpacking and Equipment Supplied

t
Open the packaging, making sure to remove all parts
carefully.
t
After unpacking the device, check it immediately for any
external damage.
t
If you detect any damage, proceed as directed in
chapter "4. Care and Maintenance," page 6.
t
Save the box and all parts of the packaging for any future
transport.
All cables should be unplugged when transporting.
The following parts are included in the equipment supplied:
Model
Large weighing pan: d 233 mm
Small weighing pan: d 180 mm
USB connection cable
AC adapter with country-specific
mains adapter
Installation instructions

3.2 Selecting a Setup Location

Select the right setup location:
− Set up device on a stable, even surface that is not exposed
to vibrations.
− Maintain free access to the device at all times.
Choose a location that is not subject to the following negative
influences:
− Heat (heater or direct sunlight)
− Drafts from open windows, AC systems, and doors
− Extreme vibrations during weighing
− Heavy traffic areas (personnel)
− Extremely high humidity
− Electromagnetic fields
− Extremely dry air
Acclimatization
Condensation from humidity can form on the surfaces of a
cold device when it is brought into a substantially warmer
area. You should therefore let a device that has been
disconnected from its power source acclimatize for
approximately 2 hours before reconnecting it to the
supply voltage.
Evolution HD
x –
– x
x x
Optional Optional
x x