Wisp Mode; Change Setup Mode; Configure Wan Setup - Cerio OW-400 A1 User Manual

7.

WISP Mode

WISP Mode is a router function, if the Telecom company permits wireless connection to their WAN,
administrators can change the CenOS 5.0 AP to WISP Mode to connect to the wifi network.
The WISP Mode support PPPoE / Static IP / Dynamic IP and PPTP for WAN, and support Repeater AP
function.
Relevant to Dual Band Devices Only: If wireless WAN used 2.4G radio
connection to Telecom company station, the Repeater AP radio only used 5G
radio. So wireless WAN used 5G radio connection to Telecom company station,
the Repeater AP radio only used 2.4G radio.

7.1 Change Setup mode

If the administrator needs to switch to WISP mode, Please click "System"-> " Mode Setup " to change
WISP mode.
Please note that the LAN IP addresses in each mode are different from each
other and will not continue. For the first time after switching modes, always
perform access management on the LAN default IP address of 192.168.2.254

7.2 Configure WAN Setup

There are four connection types for the WAN port: Static IP, Dynamic IP, PPPoE and PPTP. Please click
on System -> WAN and follow the below setting.
V4.0