Ap Control - Cerio OW-400 A1 User Manual

ETH0：Administrator select Enable/disable the Ethernet port.

VLAN Tag：Administrator can set Tag ID for the Ethernet port.

Set Gateway / DNS address functions.

Gateway: The default Gateway IP Address is 192.168.2.1, Please check your Gateway IP and

change.
DNS: Check either "No Default DNS Server" or "Specify DNS Server IP" button as desired to

set up the system DNS.
Primary: The IP address of the primary DNS server.

Secondary: The IP address of the secondary DNS server.

Click "Save" button to save your set function. Then click "Reboot" button to activate your changes.

5.3 AP Control

When CenOS5.0 AP changes to CAP mode, Administrator can use AP Control functions to centralize
management of APs in the network architecture. AP control Setting functions have "Scan Device",
"Batch Setup", "AP Setup", "Group / Map setup" and Authentication Profile setup etc..
Please click "AP Control" to enter AP Management settings
# Centralized Management APs operating Instructions:
1) Click "Scan Device" to discover Access Points in the network architecture.
2) Set IP address for all managed Access Points and reboot managed Access Points.
3) Re-Scan managed APs and Import to databases.
4) Centralize managed AP settings by clicking "AP control"  "Batch setup"
5) After the setup is complete for managed APs function, administrator must reboot all managed
APs.
V4.0