Radio 1 (5G) Basic Setup - Cerio OW-400 A1 User Manual

Channel Bandwidth:

special circumstances.
MCS: This parameter represents transmission rate. By default (Auto) the fastest possible

transmission rate will be selected. You have the option of selecting the speed if necessary.
Shout GI: Short Guard Interval, by default, it's "Enable". it's can increase throughput. However,

it can also increase error rate in some installations, due to increased sensitivity to
radio-frequency reflections. Select the option that works best for your installation.
Aggregation: By default, it's "Enable". To "Disable" to deactivated Aggregation.

A part of the 802.11n standard(or draft-standard). It allows sending multiple frames per single
access to the medium by combining frames together into one larger frame.
It creates the larger frame by combining smaller frames with the same physical source and
destination end points and traffic class (i.e. QoS) into one large frame with a common MAC
header.
Aggregation Frames: Set frames size of Aggregation, the size

is 32.
Aggregation Size: Set aggregation size, the size

Click "Save" button to save your set function. Then click "Reboot" button to activate your changes.
7.5.2

Radio 1 (5G) Basic Setup

MAC Address: Display Radio 1(5G) used MAC address.

Country: Administrator can select country used channel by US / EU and Taiwan.

Band Mode: If Client Bridge want to use 5G link to Access Point then administrator can enable

The "20/40" MHz option is usually best. The other option is available for
recommend use default value
recommends use default value is 500000.
V4.0