Cap Mode; Change Setup Mode; Vlan Setup - Cerio OW-400 A1 User Manual

5.

CAP Mode

The CAP mode itself isn't Access Point. This mode is primarily to control all the managed AP.
The following describes setup function in system menu

5.1 Change Setup mode

If the administrator needs to switch to CAP mode, Please click "System"-> " Mode Setup " to change
CAP mode.
Please note that the LAN IP addresses in each mode are different from each
other and will not continue. For the first time after switching modes, always
perform access management on the LAN default IP address of 192.168.2.254

5.2 VLAN Setup

Start by setting the AP's (LAN) IP address, Please Click "System "  " VLAN Setup"
This VLANs support max 16 IEEE 802.1q tag VLANs.
Setup "Control AP" of LAN or VLAN IP Address, Gateway, DNS and Ethernet Tag etc.
V4.0