OREC FL 500 Instruction Manual page 12

Figure 7
Only use original genuine OREC parts. Other parts may be dangerous for your health and for
the bystanders and the machine.
If some vibration occur. If you feel vibrations in the handlebar, check the blade. Vibrations
may cause loosening of the bolt and nuts and may crack the steel of the machine.
Lubrication
Grease at the rear of the wheel shaft. Do not let the grease in excess, particuliary in sandy areas
grease the niples with a gease pump, use only a good quality grease NLGIn°0.
AIR FILTER
Dismant the air filter by the two wing nuts (A Figure 9). blow the cartrige "B" with low air pressure

from the inside to the outside, oposite to the normal air flow. Change the cartridge if it is too
dusty or after five cleaning.
Clean the foam "C" with water and soap. Dry the foam before and oil slightly with engine oil, then

assembling again.
OREC FL500A - © SAT 03/03
Figure 6
CAUTION
12
Figure 8