Table of Contents
Advertisement
CHECKS BEFORE DELIVERY
•
Check that all the shields, grids and safety guards are in place and in a good state.
•
Check that the hydraulic hoses are in place and in a good state. Replace them if necessary.
•
Check that there is no oil leak, repair if necessary.
•
Check that the safety instruction stickers are in place and in a good state. Replace them if
necessary.
•
Check that all the bolts and screws are properly tightened with the right torque (refer to torque
chart).
•
Protect the grease nipples by coating them with grease and lubricate the machine.
•
Check that the machine can work properly.
CHECKS ON DELIVERY
•
Show the user how to perform the adjustments.
•
Explain to the user the importance of the lubrication and show him the different greasing points on
the machine.
•
Show him the safety devices, grids, guards and the optional equipments.
•
Give the instruction manual to the customer, ask him to read it carefully.
Some of the illustrations show the machine with no guard, no shield. Never use the machine
without these devices.
•
Learn to stop the machine in case emergency.
•
Read this manual.
•
Do not let anybody use the machine before having read and understood
this manual.
•
Do not let children use the machine.
•
Do not wear loose clothes. They might be grasped by moving parts.
•
Always wear protection equipments for when using the machine.
•
Only work during daylight or with a good artificial light.
•
Check that the safety instruction stickers are in place and in a good condition.
•
Keep the machine free from debris or mud.
•
Check that the machine can work properly before any use.
•
Check that all the shields, grids and safety guards are in place and in a good state.
•
It is strictly forbidden to carry persons or animals onto the machine during the work or during the
transportation.
•
Never stop or start roughly when working on a slope. Never use the machine to work on a
OREC FL500A - © SAT 03/03
SAFETY RULES
stepping terrain.
•
Reduce the ground speed when running on a slope and when turning
straight in order to prevent from any risk of losing control.
•
Be very careful when bordering ditches.
•
Stop the engine, and remove the sparking plug ignition cover before
any intervention on the machine.
•
Never work under the machine or its parts when lifted, unless they are
blocked and maintained into position with sufficient security.
•
When running on a slope, always work going up or down but never
across the slope.
•
Steer clear of unsteady embankments, holes or rocks. They might be
CAUTION
4
Advertisement
Table of Contents
