OREC FL 500 Instruction Manual page 13

ENGINE OIL LEVEL:
Refer to engine manual
MONTHLY MAINTENANCE
DRIVING WIRE ADJUSTMENT:
When you pull the lever for driving (Figure10, 1) the machine
start to move, there must be a distance of between 20 and 30
mm (Figure 10).
If this is not the case, adjust the tension of the change wire
by first loosening the idler adjustment nut (Figure 10,A) and
then by screwing the idler adjustment nut (Figure 10,B) until
the distance is correct. Repeat the procedure if it is incorrect.
BLADE WIRE ADJUSTMENT
Play of the blade wire:
This wire must set the blade lever between 3-8 mm (Figure
11).If this is not the case, adjust the tension of the blade wire
by first losing the tension adjustment nut (A, Figure 10), and
then by adjusting the tension adjustment nut (B, Figure 10)
until the play is correct. Tighten the tension adjustment nut to
secure it then check if the setting is correct. Repeat the pro-
cedure if it is incorrect.
:
CHANGE WIRE
If the machine does not stop when the driving lever is released,
unscrew the tension adjusting nut of the change wire (B, Figure
12). Adjust the tension adjustment nut of the change wire if
necessary. Tighten the adjustment nut to secure it then check if the machine is operating normally.
Repeat the procedure if the machine does not function normally.
If, despite the adjustment of the change and driving lever to the correct settings, the machine does
not move, do the following.
OREC FL500A - © SAT 03/03
A
C
Figure 9
13
B
Figure 10
Figure 11