OREC FL 500 Instruction Manual page 16

M
AINTENANCE CHART
Ask your dealer to realize this operation needing special tools and knowledge.
⊕ Inspection to realize by the owners before starting the engine
⊗ Inspection to realize by the owners after starting the engine
Part to inspect
Blade belt
Fuel
Flammables Clean the machine from flammables
materials
Drive clutch lever
Check travel lever goes on "N" when
Chasis
Safety stickers Check they are in place and in good
Safety switches
Guards & shields Check they are bolted in their place
Tank and fuel Check for leaks and good condition
hoses
Throttle lever
Blades Check they are bolted in their place
Blade clutch
control lever
Blade brake
Blade belt Check they tensionned and in good
Engine
Rear Wheel
Check if gears are properly greased.
OREC FL500A - © SAT 03/03
Inspection
Check belt tension
Check wear
refuelling
Fuel cock
materals
check machine do not move when
lever is on "N"
applying brake
Check for rust, and cracks
condition
Check for efficiency
and in good condition
Replace if needed
Check for efficiency
and in good condition
Check the adjustment of the wire
Check the adjustment
condition
Refer to engine manual
Clean inside of wheel
Every first
use 20
hours
⊕
⊕
⊕
⊗
⊗
⊕
⊗
⊕
⊕
⊗
⊕
⊕
⊕
⊕
16
Every Every 300
100 hours or
hours Every year