Master/Slave Mode - Equinox Systems Helix Scan XP 150W Scanner User Manual

Master/slave mode:

To set the master unit, press the "MENU" button and use the "UP" and "DOWN" buttons on the rear
NASt
of the unit to show
"DOWN" buttons to choose
Then select your desired program.
To set the other units in slave mode, press the "MENU" button and use the "UP" and "DOWN" buttons
on the rear of the unit to show
"UP" and "DOWN" buttons to choose either
rotation direction to master) or
Press the "ENTER" button to confirm the setting. The unit will now run in sequence with the master unit.
To exit out of any of the above options, press the "MENU" button.
Please ensure that all slave units are set to the same DMX channel mode as the master unit.
Show mode:
To access the show modes, press the "MENU" button and use the "UP" and "DOWN" buttons on the rear
SHnd
of the unit to show
"DOWN" buttons to choose between
and "DOWN" buttons to select the brightness between
and use the "UP" and "DOWN" buttons to select the speed between
In Show 4 you can set a specific colour with all gobos. Press the "ENTER" button again and use the "UP"
and "DOWN" buttons to select the colour between
In Show 5 you can set a specific gobo with all colours. Press the "ENTER" button again and use the "UP"
and "DOWN" buttons to select the gobo between
In Show 6 you can set a specific colour with a specific gobo. Press the "ENTER" button again and use
the "UP" and "DOWN" buttons to select the gobo between
once more and use the "UP" and "DOWN" buttons to select the colour between
Press the "ENTER" button to confirm the setting. To exit out of any of the above options, press the
"MENU" button.
*Please note: The dimmer setting in the show modes via the menu takes priority over DMX, this should be set at 255 to be
fully controlled via DMX.
Show 0 Show 0 (All shows)
Show 1 Show 1 (All gobos & colours inc. split colours)
Show 2 Show 2 (Slow mode non-reactive to sound)
Show 3 Show 3 (All gobos & colours exc. split colours)
www.prolight.co.uk
on the LED display. Now press the "ENTER" button and use the "UP" and
on oFF
choose . Press the "ENTER" button to confirm the setting.
SLnd
on the LED display. Now press the "ENTER" button and use the
SL1
(copies master),
SL3
(opposite mirror dish rotation direction and colour to master).
on the LED display. Now press the "ENTER" button and use the "UP" and
SH-0 SH-6
~
Go00
Helix Scan XP 150W Scanner User Manual
Operating instructions
SL2
. Now press the "ENTER" button and use the "UP"
d000 d255
~ . Now press the "ENTER" button
SP00
Co00 Co16
~ .
Go07
~ .
Go00 Go07
~
Show 4 Show 4 (All gobos, colour selected via menu)
Show 5 Show 5 (All colours, gobo selected via menu)
Show 6 Show 6 (Colour and gobo selected via menu)
(opposite mirror dish
SP99
~ .
. Press the "ENTER" button
Co00 Co16
~ .
15