Master/Slave Mode - Equinox Systems Blitzer Strobe User Manual

Master/slave mode:

To set the master unit, select your desired program (sound active, auto, strobe or fade modes).
To set the other units in slave mode, press the "MENU" button on the front of the unit to show
on the LED display. Press the "ENTER" button to confirm the setting. The unit will now run in sequence
with the master unit. To exit out of any of the above options, press the "MENU" button.
Please ensure that all slave units are set to the same DMX channel mode as the master unit.
Strobe mode:
To access the strobe mode, press the "MENU" button on the front of the unit to show
LED display. Now press the "ENTER" button and use the "UP" and "DOWN" buttons to choose
Press the "ENTER" button and use the "UP" and "DOWN" buttons to select the brightness between
00 99
~ . Value: 00 - 99 (00 = low, 99 = high). Now press the "ENTER" button and use the "UP" and
"DOWN" buttons to choose
to select the strobe speed between
Value: 00 - 99 (00 = slow, 99 = fast). To exit out of any of the above options, press the "MENU" button.
Fade mode:
To access the fade mode, press the "MENU" button on the front of the unit to show
display. Now press the "ENTER" button and use the "UP" and "DOWN" buttons to choose
Press the "ENTER" button and use the "UP" and "DOWN" buttons to select the fade speed between
00 99
~ . Value: 00 - 99 (00 = slow, 99 = fast). Now press the "ENTER" button and use the "UP" and
"DOWN" buttons to choose
to select the strobe speed between
Value: 00 - 99 (00 = slow, 99 = fast). To exit out of any of the above options, press the "MENU" button.
Auto mode:
To access the auto mode, press the "MENU" button on the front of the unit to show
LED display. Now press the "ENTER" button and use the "UP" and "DOWN" buttons to select the auto
program speed between
Value: 00 - 99 (00 = slow, 99 = fast). To exit out of any of the above options, press the "MENU" button.
Sound/sound sensitivity:
To access the sound mode, press the "MENU" button on the front of the unit to show
LED display. Now press the "ENTER" button and use the "UP" and "DOWN" buttons to select the sound
00
sensitivity between
Value: 00 - 99 (00 = low, 99 = high). To exit out of any of the above options, press the "MENU" button.
www.prolight.co.uk
CF. 0 0
. Press the "ENTER" button and use the "UP" and "DOWN" buttons
00 99
~
FF. 0 0
. Press the "ENTER" button and use the "UP" and "DOWN" buttons
00 99
~
00 99
~ . Press the "ENTER" button to confirm the setting.
99
~ . Press the "ENTER" button to confirm the setting.
. Press the "ENTER" button to confirm the setting.
. Press the "ENTER" button to confirm the setting.
Blitzer Strobe User Manual
Operating instructions
C000
FA00
on the LED
FA. 0 0
AUTO
on the
SOUN
SLAU
on the
C1. 0 0
.
.
on the
7