Equinox Systems Helix Scan XP 150W Scanner User Manual page 12

DMX mode:
Operating in a DMX control mode environment gives the user the greatest flexibility when it comes
to customising or creating a show. In this mode you will be able to control each individual trait of
the fixture and each fixture independently.
To access the DMX address mode, press the "MENU" button and use the "UP" and "DOWN" buttons on
the rear of the unit to show
and "DOWN" buttons to set the required DMX address. Press the "ENTER" button to confirm the setting.
To exit out of any of the above options, press the "MENU" button.
DMX channel mode:
To access the DMX channel mode, press the "MENU" button and use the "UP" and "DOWN" buttons on
the rear of the unit to show
and "DOWN" buttons to choose one of the 2/10 or 12 DMX channel modes. Press the "ENTER"
button to confirm the setting. To exit out of any of the above options, press the "MENU" button.
2 channel mode:
Channel Value Function
000-012 Blackout
013-045 Show 0 (All shows)
046-080 Show 1 (All gobos & colours inc. split colours)
Show 2 (Slow mode non-reactive to sound/
081-115
speed setting)
CH1
116-150 Show 3 (All gobos & colours exc. split colours)
151-185 Show 4 (All gobos, colour selected via menu)
186-220 Show 5 (All colours, gobo selected via menu)
221-255 Show 6 (Colour and gobo selected via menu)
CH2 000-255 Show speed (slow-fast)
*Please note: The dimmer setting in the show modes via the
menu takes priority over DMX, this should be set at 255 to be
fully controlled via DMX.
The show mode motor speed is only controllable when Sound
Active mode is set to OFF in the menu.
www.prolight.co.uk
Addr
on the LED display. Now press the "ENTER" button and use the "UP"
CHnd
on the LED display. Now press the "ENTER" button and use the "UP"
Helix Scan XP 150W Scanner User Manual
Operating instructions
12