Master/Slave Mode - Equinox Systems Graphix User Manual

Master/slave mode:

To set the master unit, press the "MENU" button and use the "UP" and "DOWN" buttons on the rear
NASt
of the unit to show
"DOWN" buttons to choose
Then select your desired program.
To set the other units in slave mode, press the "MENU" button and use the "UP" and "DOWN" buttons
on the rear of the unit to show
"UP" and "DOWN" buttons to choose either
rotation direction and glass wheel rotation direction to master).
Press the "ENTER" button to confirm the setting.
The unit will now run in sequence with the master unit.
To exit out of any of the above options, press the "MENU" button.
Please ensure that all slave units are set to the same DMX channel mode as the master unit.
Show mode:
To access the show modes, press the "MENU" button and use the "UP" and "DOWN" buttons on the rear
SHnd
of the unit to show
"DOWN" buttons to choose between
and "DOWN" buttons to select the speed between
In Show 3 you can set a specific pattern. Press the "ENTER" button again and use the "UP" and "DOWN"
buttons to select the pattern between
"UP" and "DOWN" buttons to select the speed between
Press the "ENTER" button to confirm the setting.
To exit out of any of the above options, press the "MENU" button.
SH-0
Show 0 (All shows)
SH-1 Show 1 (Mirror dish and pattern wheel in both directions, no strobe)
SH-2
Show 2 (Mirror dish and pattern wheel in both directions, no strobe, slow mode non-reactive to sound)
SH-3 Show 3 (Mirror dish in both directions, pattern wheel static - selected in menu)
SH-4 Show 4 (Mirror dish CW, pattern wheel CW)
SH-5
Show 5 (Mirror dish CW, pattern wheel CCW)
SH-6 Show 6 (Mirror dish CCW, pattern wheel CW)
SH-7 Show 7 (Mirror dish CCW, pattern wheel CCW)
SH-8
Show 8 (Mirror dish and pattern wheel in both directions, some strobe)
Sound active:
To access the sound active setting, press the "MENU" button and use the "UP" and "DOWN" buttons on
the rear of the unit to show
and "DOWN" buttons to choose between
To exit out of any of the above options, press the "MENU" button.
www.prolight.co.uk
on the LED display. Now press the "ENTER" button and use the "UP" and
on oFF
choose . Press the "ENTER" button to confirm the setting.
SLnd
on the LED display. Now press the "ENTER" button and use the
SL1
(copies master) or
on the LED display. Now press the "ENTER" button and use the "UP" and
SH-0 SH-8
~
P000 P255
~
SoUn
on the LED display. Now press the "ENTER" button and use the "UP"
on ofF
or
Operating instructions
SL2
. Now press the "ENTER" button and use the "UP"
SP00 SP99
~ .
. Now press the "ENTER" button and use the
SP00 SP99
~
. Press the "ENTER" button to confirm the setting.
Graphix User Manual
(opposite mirror dish
.
9