Canon Canovision8 E50E Service Manual page 150

3-13 Eject Lever, Switch Lever, Pinch Sub Arm
® Disassembling (Pig.II-20)
(1) Set unloading state.
(2) In the same procedures in "3-3", dismount the capstan motor.
(3) To dismount the eject lever @, unhook-the claw @.
(4) To detach the switch lever @, remove the washer ©.
{5) Remove the spring ©.
(6) To detach the pinch sub arm @, remove the washer ©.
*Reassembling (Fig.II-20)
(1) Apply the grease onto the shaft ©. (Fig.A)
(2) Assemble the pinch sub arm @ while inserting the @ part into the slot ©.
(3) Secure it with the washer ©.
(4) Hook the © part of spring @ between the claw @ and the chassis side while
hooking © part to the claw @.
(5) Apply 1/2 drop of oil to the shaft @. (Fig.B)
(6) Assemble the switch lever @ to the shaft @ while aligning the grodve @
with the projection ® of mode switch. At this time, insert the pin @ to
the outside groove @ of drive gear (left) ®.
(7) Secure it with a washer @.
(8) Attach the eject lever @ and hook the claw @.
(9) In the same procedures in "3-3", mount the capstan motor.
*Note: When installing the switch lever @ to the shaft @, set the pin @ of
tension regulator arm to the inside of switch lever @. (within the
extent of @ indicated by an arrow.)
@wWasher a
@spring. 9 ®
* ery | Switch
= @Pinch | sub Eee lever
Aa Eject lever
@brive gear (left)
| 4 A/2 os oil}
Grease ae
@saler—ol. mee Qciaw
—_ @rrojection
Fig.A Fig.B {Mode switch)
Fig.I1-20
pte
ed