Canon Canovision8 E50E Service Manual page 141

3-3 Capstan Motor
* Disassembling (Fig.II-9)
(1) Set the unloading state.
(2) Rotate the stopper @ in direction @ until it comes to an end.
(3) To take out the capstan motor @, remove the two set screws @.
* Reassembling (Fig.II-9)
{1) Align the two dowels @ with the two holes © to match the gear section ©
with the connecting gear @.
(2) Secure the capstan motor @ with the two set screws ®.
(3) Rotate the stopper @ in direction of ® until it comes to an end.
*Notes: 1. Do not match the gear section © and the connecting gear @ forcibly
* to prevent the cam grooves damaging.
2. Fit the capstan. motor @ and the chassis without space.
3. Do not touch the capstan motor shaft, the rotor section and the oil
seals,
@screws
*Capstan
motor
shaft
*Oiil seals
@Gear @capstan motor
*Roter
Fig.II-9
27
RE