Emerson Rosemount FCL-01 Reference Manual page 26

Display and operation
October 2023
2. To assign values to the analog outputs, open the
3. To view the other items, use Down to scroll to the last item shown and continue
4. Press ENTER.
26
move the cursor to
Program
The Program menu appears. There are between five and seven items in the Program
menu.
Diagnostic Setup
pH sensor. The screen displays four items at a time. The downward pointing arrow
on the right of the screen shows there are more items available in the menu.
scrolling down. When you have reached the bottom, the arrow will point up. Move
the cursor back to
Outputs
The Outputs screen appears. The cursor is on
values to the low and high current outputs.
The Output Range screen appears. The screen shows the present values assigned to
output 1 ( ) and output 2 (
O1
are assigned to. is sensor 1. The assignments shown are the defaults for the
S1
FCL-01. Outputs are freely assignable under the Configure menu.
Program
. Press ENTER.
appears only if you have the Rosemount FCL-02 with
and press ENTER.
Range
). The screen also shows which sensors the outputs
O2
Reference Manual
00809-0100-3412
sub-menu. Use Down to
. Output range is used to assign
Emerson.com