Trouble Shooting Guide - Univex SRM30+ Parts And Service Manual

Planetary mixer
Hide thumbs Also See for SRM30+:
Table of Contents

Advertisement

TROUBLE
1. Mixer will not operate.
2. Mixer runs but agitator
will not turn.
3. Agitator stalls during
mixing.
4. Speed does not change
properly.
5. Mixer runs, but
repeatedly cuts out and
stops.
6. Attachments contact
bottom of bowl.
SRM30+ TROUBLESHOOTING GUIDE
POSSIBLE CAUSE
1.1 Timer not turned on.
1.2 Burned switch contacts.
1.3 Electrical service down.
1.4 Motor capacitor defective.
(1 HP only)
1.5 Burned out motor.
1.6 Magnetic starter tripped
due to overload.
1.7 Safety ring not mounted
or closed.
1.8 Bowl not raised.
2.1 Drive belt off pulley.
2.2 Key or pin sheared on
input shaft, input gear,
bevel pinion, bevel gear,
vertical shaft or beater
head.
2.3 Shifting speed with mixer
not running.
3.1 Mixer bowl is overloaded.
3.2 Speed is set to high for
the mix.
3.3 Loose belt.
3.4 Contamination of belt
with grease.
4.1 Loose belts.
4.2 Vari-speed pulley
inoperative.
5.1 Bowl overloaded.
5.2 Speed is set too high for
the mix.
5.3 Service voltage too low or
fluctuating.
5.4 Starter improperly set.
6.1 Dented bowl.
6.2 Bowl height is set too
high.
Page 1.1
REMEDY
1.1 Turn timer on.
1.2 Replace.
1.3 Check electrical service.
Replace fuse or reset circuit
breaker if necessary.
1.4 Replace motor.
1.5 Remove, test, repair or
replace.
1.6 Wait several minutes and
push start button.
1.7 Install safety ring.
1.8 Raise bowl completely.
2.1 Reinstall drive belt on motor
pulley and adjust mounting
center distance.
2.2 Locate by step inspection and
replace defective part.
2.3 With mixer running, slowly
move speed control lever
fully forward then backward
to re-engage belt.
3.1 Adjust contents of bowl.
3.2 Shift speed lower till action
rotates smoothly.
3.3 Readjust pulley center
distance to tighten belt.
3.4 Clean pulleys and replace
belt.
4.1 Tighten or replace belts.
4.2 Remove, clean and lubricate
or replace.
5.1 Adjust contents of bowl.
5.2 Reduce speed.
5.3 Check electrical voltage.
5.4 Adjust amp setting on starter.
6.1 Remove dent or replace bowl.
6.2 Reset bowl height.

Advertisement

Table of Contents
loading

Table of Contents