Table of Contents
Advertisement
MECHANICS MAINTENANCE
2. MOTOR:
Check the motor (Figure 10 [29]) for overheating, noise and excessive end play of the shaft.
Replace the motor if defective.
3. BOWL LIFT ADJUSTMENT: (Figure 8 and 9)
a. Place the 30 quart mixing bowl on the bowl support (Figure 1 [17]) and the 30 quart batter beater
on the beater head shaft (Figure 1 [1]).
b. Raise the bowl support to the up position.
c. Check the clearance between the bottom of the bowl and the lowest point of the batter beater.
The clearance should be 3/16 inch, plus or minus 1/16 inch.
d. If adjustment is required, disconnect the electrical power supply cord, loosen the lock nut
(Figure 9 [11]) and turn the connecting rod Figure 9 [12]) until the correct clearance is obtained.
Retighten the lock nut.
connecting rod
Page 2.2
Advertisement
Table of Contents
