Power Take Off Assembly - Univex SRM30+ Parts And Service Manual

POWER TAKE-OFF ASSEMBLY: (Figure 6)
1. Remove the retaining ring Figure 6[10]) from the end of the PTO shaft [14] and remove the
spur gear [15] from the PTO shaft.
2. Remove the three 1/4-20 hex head cap screws (Figure 6 [9 & 18]), Washers (8 & 19]),
deflector [7], retaining ring [10] at the gear [15] end of the shaft. Thread two of the 1/4-20
screws into the threaded holes in the transmission housing and turning the screws alternatly,
jack the power take-off assembly from the transmission housing.
NOTE: Gear [15] should be replaced as a set with the input spur gear PN1020010.
spur gear
power take-off housing bevel gear
power take-off assembly
Page 3.7
bevel gear
1/4-20 hex screws
lubrication deflector
power take-off shaft