MECHANICS MAINTENANCE
a. The top cover (Figure 12 [4]) must be removed to perform maintenance operations on the mixer.
It is secured by a spring clip at its front end and a screw in back. Before removing the top cover
DISCONNECT THE ELECTRICAL POWER CORD. Remove the screw in the rear, lift the rear
of the cover and push it forward about 2 inches and lift it off.
b. Reinstall the top cover in the reverse of the above procedures using care to insure that the cover
sits squarely and uniformly on the mixer housing.
top cover
REMOVAL OF TOP COVER
top cover screw
Page 2.4
rear access panel