Summary of Contents for Univex 1000M Signature Series
Page 1
1000M MANUAL Signature Series Slicer OPERATORS MANUAL Persons under age 18 are not permitted to operate or have accessibility to operate this equipment per U.S. Dept. Of Labor Employment Standards Administration Fact Sheet No. ESA91-3. 1000M ED 2...
Page 2
TO INSURE BOTH SAFE AND TROUBLE-FREE PERFORMANCE WE STRESS THAT ALL PERSONNEL THAT WILL BE INVOLVED WITH YOUR NEW UNIVEX SLICER MUST READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE ATTEMPTING TO OPERATE THIS UNIT....... WE APPRECIATE YOUR COOPERATION AND YOUR BUSINESS.
INSTALLATION INSTRUCTIONS INSPECTION All UNIVEX slicers are inspected and tested at the factory; however, they should be inspected carefully by the person making the installation for loose, damaged or broken parts. Detached parts and fixtures should be checked against packing list to determine all are present.
(Figure 1 [10]). Do not hold or push the carriage from any other place. OPERATION INSTRUCTIONS The UNIVEX slicer is designed to meet the cook's demand for an efficient, sturdy slicer. The UNIVEX slicer will give unfailing performance over a period of years, when operated and maintained according to instructions contained herein.
Warning: The following sharpening procedure will provide high quality sharpening results and should also be followed for safety considerations: 1. Warning: Keep away from the knife edge. 2. The knife cutting area should be clean and free from food, especially grease. Grease will ruin the ability of a grinding stone to sharpen an edge.
1 LOCKING KNOB ASSEMBLY 2 HONING POSITION 3 SHARPENER OPERATION SELECTION DIAL 4 SHARPENER NEUTRAL POSITION 5 SHARPENING POSITION FIGURE 3 POSITION THE SHARPENER ASSEMBLY SO THAT THE LOCKING KNOB ASSEMBLY IS BEHIND THE FENCE. SLIDE THE CARRIAGE FORWARD UNTIL THE PLASTIC BEAD SLIPS INTO THE NOTCH ON THE FENCE.
OPERATORS CARE OF SLICER CLEANING Warning: 1. Never touch the knife edge. Always keep your hands, fingers and arms clear of knife. Warning: 2. Turn off slicer and DISCONNECT ELECTRICAL CORD before cleaning. Turn slice adjustment knob (Figure 1 [11]) to the fully closed position (beyond "0") so that the knife edge is not exposed.
LUBRICATION & FUNCTION CHECK Warning: Turn off slicer and DISCONNECT ELECTRICAL CORD before lubricating. Close fence all the way. General lubrication should be performed in accordance with the lubrication instructions below. During this lubrication sequence, be sure to check for free operation and movement of related parts as well as for excessive wear and looseness of various parts.
UNIVEX. Damages incurred in transit or incurred because of installation error, accident, alteration or misuse are not covered. Transit damages should be reported to the carrier immediately. UNIVEX will not be liable for any consequential, compensatory, incidental or special damages.
Need help?
Do you have a question about the 1000M Signature Series and is the answer not in the manual?
Questions and answers