Table of Contents
Advertisement
VARI-SPEED ASSEMBLY
11. Loosen the screws on the starter which secure the motor cord power leads (Figure 10 [14]). Remove the
10-32 nut, lock washer and the motor cord ground lead from the weld stud. Remove the 10-32 nuts and
cord clamps.
12. Remove the four 5/16-18 Kep nuts securing the motor [3] and remove the motor from the mixer housing.
Loosen the set screw on the pulley [2] and slide the pulley and key off the motor shaft.
13. Remove the two screws securing the cover plate on the rear of the motor. Remove the green grounding
screw securing the motor cord ground lead. Remove the wire nuts and pull the motor cord from the
motor.
motor power cord
ground lead weld stud
5/16-18 Kep nuts
Page 6.2
grounding screw
cover plate
Advertisement
Table of Contents
