Step 3 - Connect The External Rf Cables And Antenna; Step 4 - Connect The Power Cables - Futurecom PDR8000 Deployment Manual

PDR8000® Portable Digital Repeater and Booster Pack Deployment Guide
Step 3 – Connect the External RF Cables and Antenna
The simplex configuration requires one external RF cable and an antenna. This cable and the
antenna shall be connected as follows (refer to Figure 30 for wiring diagram)
1. Connect an RF cable to ANT port on the side panel of PDR8000 and the other end of it
to RF IN connector on the Booster Pack's side panel
2. Connect the antenna to the RF OUT connector on the Booster Pack's side panel
Step 4 – Connect the Power Cables
Once the AUX, RF cables and antenna are connected, the power cables (AC or DC) shall be
connected to PDR8000 and Booster Pack. Ensure that the power cables to the units are
connected securely before plugging the cables to wall outlet or DC power supply.
1. Connect the DC or AC power cable to PDR8000
2. Power up the PDR8000
3. Connect the DC or AC power cable to Booster Pack
4. Power up the Booster Pack after the PDR8000 has been powered up
December 2023
Document 8K088X03 R5.04
Page 28 of 35