Table of Contents
Advertisement
Connecting cable installation
Fig. 61: Grounding connections on transmitter and sensor
1
2
3
13.3 Connecting cable installation
With remote type flow meters, sensors and transmitters are connected by means of
connecting cables.
Risk of damage to the flow meter due to incorrect sealing
CAUTION
In case of metric cable entry ensure appropriate IP rating and suitability of O-ring of used
accessory (e.g. cable glands).
In case of NPT cable entry ensure appropriate sealing measures (e.g. use of sealing
tape).
In order to obtain optimum measuring results and ensure compliance with the
specification, it is imperative that an original connecting cable and original glands from
Siemens are used. In order to ensure the IP code, the cable must be professionally
installed at the entries. If necessary, the cable may be shortened using the enclosed
termination kit. Refer to the cable termination instructions enclose to each termination kit
that is attached to each cable.
Fig. 62: Cable gland parts mounting
1
2
3
4
Grounding screw in transmitter terminal box for grounding conductor
Grounding terminal on transmitter for potential equalization
Grounding terminal on sensor for potential equalization
1
2
3
Cap nut
Connecting cable
Plastic part
Inner cone part
1
2
3
4
5
6
7
5
Outer cable shield
6
Outer cone part
7
Mounting thread
8
Housing cable entry
A5E52748387-AA, 2023/09
FC7x0
Wiring
8
107 / 180
Advertisement
Table of Contents
