Advertisement
Printer
Problem
Check Point
Cause and Action
The printer connected with the
station is turned ON but does not
operate.
Is not the station OFF?
When the printer is connected
with the station, it does not
operate unless the station is ON.
Turn the station on.
Although the battery pack has
been installed in the printer, it is
turned ON but the power lamp
does not light up.
0
Is not the battery pack
installed
in
a
reverse
orientation?
0
Does not the battery lamp
light up green and yellow
alternately or only yellow?
0
Check if the battery pack is in
a correct orientation (see page
17).
0
Charge the battery pack.
The printer power lamp flashes
on and off.
0
Is not the battery pack nearly
empty?
0
Is the paper roll correctly iristalled?
0
Is not the printer release lever
left free?
0
Charge the battery pack.
0
See "8. Maintenance" (page
41) to reinstall the paper roll.
0
Push down the printer release
lever.
A continuous beeping sound
0
Is the paper correctly installed?
0
Is there proper RS-232C
connection with an external
device or is the external device
working properly?
0
Refer to 08 Maintenacej
(page 41). Re-insert the paper
correctly.
0
Malke sure the interface cable
is property connected on both
ends. Read the external device
manual carefully.
Nothing is printed.
0
Do you use a designated
printer roll?
0
Is not the printer release lever
left free?
0
Is not the paper roll inserted
upside down?
0
Use a designated printer roll.
0
Push down the printer release
lever.
0
See "8. Maintenance" (page
41) to reinstall the paper roll.
The printer does not receive
measurement data sent from the
measuring unit.
Does the measuring unit address
correspond
with
the
printer
address?
Check
the
setting
on
the
OUTPUT unit presetting screen
(see page 40) and the printer DIP
switch (see page 34) and make
the two addresses match.
47
Advertisement
