Advertisement
E] 4. Preparation
(1) Attach the strap to the measuring unit.
(see Figure 4-1)
(2) Connect the power cable to the power cable
receptacle located on the station.
(3) Make sure that the station power switch is set to
OFF, and plug the power cable into a wall outlet
(AC100 V).
(4) Turn the stations power switch on.
The power lamp will illuminate.
(5) Install the battery pack in the measuring unit.
— See "5.
Charging the Battery Pack"
(Figures 5-1,5-2 and 5-3 in page 15).
(6) Charge the battery about 90 minutes by placing
the measuring unit on the station.
See "5.
Charging the Battery Pack"
(page 16).
*
A new battery pack is fully discharged and must
be charged about 90 minutes before initial use.
** When a new battery pack is installed or after the
unit has not been for a long time, it will require
the battery to charged/discharged a few times in
order to permit the battery to hold a proper
charge for use.
When you charge your battery for the first
time you may get an indication of charging
complete after just 10 to 15 minutes. This is
normal and can happen with all rechargeable
batteries when first charged.
i
Push the CHARGE key. If the CHARGE lamp is
not illuminate, repeat the pushing the CHARGE
key.
(7) Install the print on paper roll.
See "8,
Maintenance" (page 41).
(8) Connect the printer with the station.
(see Figure 5-10 in page 18)
(9) Turn the printer power switch on.
* When the printer is connected with the station,
it cannot be used unless the station is ON.
(10) Remove the measuring unit from the station,
and turn the measuring unit on.
Figure 4-2
13
Advertisement
