Advertisement
(5) Charging the optional spare battery pack
1) Install the spare battery pack in the printer battery box by following the procedure
described in "(2) Automatic charging of the printer battery pack", "1) Replacing the battery
pack".
2) Charge the spare battery pack in the same way as charging the printer battery pack.
3) After the charging is complete, remove the spare battery pack.
Important: Before using the battery pack, read the operation manual thoroughly which was provided
with the unit.
Note
; Use only toe DURACELL DR10 battery.
(6) Advise and confirmation
1) If is normal for the battery to become warm after use or charging.
2) When the charging is started, the measuring unit and printer were used for 30 minutes or
were charged before 3 hours.
3) After renewing or charging, in the case that the measuring unit or printer has catched the
station for 2 hours and press the RENEW or CHARGE key. these key is not able to set in
once. This case is not unusual, becuase of the avoiding the over charging.
4) The case that for charging or renewing, the CHAGE or RENEW lamp goes on and off,
there may unusual. Do the next way.
Remove the measuring
unit or printer from the
station
Connect with the station againj
"►and press the CHARGE key.
After the CHARGE lamp was illuminate, the
case that the lamp go off uniti 90 minutes is
* normal.
In the case that the CHARGE lamp goes on
and off again, the battery is unusual
Change the battery and connectLUiiuminate
wrth the station, and press thej | '———
CHARGE key
The CHARGE lamp i^
the
CHARGE
on and off.
lamp
In the case that the lamp go off
♦ unit! 90 minutes, the battery is
normal
+ The station is unusual
Please
consult
with
your
Nikon
5) The measuring and printer can use remove the station before completing the charging.
21
Advertisement
