Advertisement
4) When the printer cannot operate normally for reasons such as the passing of a person between
the measuring unit and the printer while data is being sent, the printer Data lamp will illuminate
yellow in color and a beep sounds.
The printer may not operate at all if infrared rays do not
reach it.
In these cases, get closer to t he printer and press the PRINT key again.
Data can be printed any number of times until the next measurement is performed. When you
start the next measurement after pressing the PRINT key, the patient number is incremented by
one.
Set^ng
the Printer DIP Switch
When
using two or more printers in a room, the DIP switch (see Figure 6-16) of each printer
should be set as shown in the following figure to prevent radio interference.
The printer addresses will correspond to the measuring unit addresses (see Figure 6-17).
Figure 6-18
Sending
of
Data from
Measuring unit to Printer
34
Advertisement
