Advertisement
Automatic Fogging System
The purpose of the automatic fogging System the patient eye correctly and then minimize the patients
eye accommodation.
When the patient's eye is aligned with the Retinomax, the fogging is then
automatically made .
The target will slightly blurs,
i
When the alignment for the measurement is complete, the target will blur further (enters the fogging
state).
The instrument will beep while it performs the measurement process.
When stop beeping, one measurement cycle has been completed.
The patient will now see a dim target.
I
Measurement Is repeated
j while
remaining
in
the
! fogging state.
The next measurement cycle starts.
You may also disable the automatic fogging mechanism by switching the unit to the quick mode.
(See page 28.)
- Power Saving
---—
When any key is not pressed for 3 minutes or more, the measuring unit is automatically turned OFF.
To restart measurement, press the POWER key.
The lOL ^es measurement
The Retinomax will automatically measure lOL eyes (intraocular lens-contained eyes) in the same
process as normal
eyes without any special switch setting.
lOL eyes should be measured as
many times as possible (at least 8 cycles), because the measured values may vary in a wider range
when compared with normal eyes.
26
Advertisement
