Emerson Rosemount Wireless WT210 Quick Start Manual page 8

Quick Start Guide
Example shown below is for a NPS 14" (DN 350) pipe.
Measure & Cut (with tinsnips):
Cut across bottom of hole closest to measurement.
Note
It is recommended that one side of the Strap is secured to the
mount prior to placing the mount on the asset. This will make
the full installation easier once the mount has been placed on
the asset.
3. Loosen the 2 x m6 bolts in the Strap Holder using the 10 mm
socket such that they cannot be seen or felt behind the Strap
Holder. These bolts do not have to be removed fully to slide
the Strap into the Strap Holder.
8
NPS DN
18 150
20 500
Strap length Strap length
(mm) (in.)
1430 56.30
No cutting required
Emerson.com/Rosemount
October 2023